| Integrated Gear Software: 60-552 |
| This model covers the design and durability rating of double enveloping worm gear speed reducers of the following types: |
 |
|
| Integrated Gear Software: 60-554 |
| This model has been prepared to help you with the design of new worm drives or to analyze existing worm sets. The model has been configured to help you design a good worm drive and design the cutting tools required at the same time. |
|
|
| Integrated Gear Software: 60-560 |
| This model is written in accordance with AGMA Standard 217.01 to provide data on the scoring resistance of gear sets used in aerospace applications. |
|
|
| Integrated Gear Software: 60-610 |
| The primary purpose of this model is to provide an accurate set of coordinates for use in plotting the final form of external involute spur and helical gears. |
|
|
| Integrated Gear Software: Formulas for Involute Gears |
| These are a handy reference for those times that you have to make some quick hand calculations. Download the PDF file to keep it close at hand on your PC or print it for a ready desk reference. |
|
|
| Integrated Gear Software: 60-710 |
| The primary purpose of this model is to provide data from ANSI Standard B92.1-1970 for Involute Splines and Inspection. This is the standard for inch-series splines based on a stub diametral pitch design. |
|
|
| Integrated Gear Software: 60-720 |
| The primary purpose of this model is to provide data from ANSI Standard B92.2M-1980 for Involute Splines and Inspection (Including B92.2Ma-1984). |
|
|
| Integrated Gear Software: 60-740 |
| This model will calculate the stress and/or spline life from the geometry and load data for steel spur involute splines. Fixed, flexible straight and flexible crowned splines are included. |
|
|
| Integrated Gear Software: 60-750 |
| This model will allow you to check the suitability of spline cutting or molding tools to produce an internal/external spline set or to design new tools. |
|
|
| Integrated Gear Software: Program 500 |
| Program 500 is a gear analysis program for external involute gears and involute splines. It is based upon American Gear Manufacturers' Association (AGMA) Standards. |
|
|
